The windscreen saga continues
So the screen was completely stripped and the more paint and bar work removed the worse it looked. I first removed the centre cross brace and replaced it to keep things square. I removed and made new sections of lower frame as the old ones were rotten just above the forward bend for about 150-200mm. The section below the vent was removed right across at this stage too. We flattened out the old bottom section to get a basic shape for the new one and cut it out. Then dummied it on to see how well it fit. Don stepped in as master manipulator of metal and got some nice curves going on along the cowl edge. Two monkeys in a Jeep Nest was to hammer weld the bottom section and another couple of patches in. Don to the rescue again with his pretty welds - kind of important as I'll be able to see the backs of them every time we go out! Next a bit of a clean up where I'd tacked panels, drill the cross braces for the wiper motors and then